Electrodragon ESP LED Strip Board, Mosfet Drive LED Controller
Available from:
Electrodragon.com
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | None |
| GPIO05 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | PWM3 |
| GPIO13 | PWM2 |
| GPIO14 | PWM4 |
| GPIO15 | PWM1 |
| GPIO16 | Led1 |
| FLAG | None |
Configuration (old format, will be converted to new template when applied)
{"NAME":"LEDBoard RGBW","GPIO":[0,0,0,0,0,0,0,0,39,38,40,37,52],"FLAG":0,"BASE":18}Alternative template for WS2812 LEDs:
Template {"NAME":"LEDBoard W2812","GPIO":[0,0,7,0,0,0,0,0,0,0,0,0,52],"FLAG":0,"BASE":18}
Description
- Based on ESP8266 Wifi IC, ESP-12F module.
- One channel RGB LED strips (can also be used for three channels LED strips)
- One extra channel white LEd strips.
- Jumper select to support WS2812 LED strips or ring board.
- Input voltage 6-27V, also power LED strip, if LED strip is 12V, input voltage should be 12V. For WS2812, input voltage should use 5V.
- On board Mosfet control is FR1205, support up to 44A/55V, for low light 5050 white led strip is about 0.4A 12V(5W), so technically support up to 100 meter per channel.
- Lead out all extra pins of ESP-12F for other use. Two buttons – flash and reset.
- Package Inlcudes:
- Main control board
- Plastic case kit (smaller than ESP relay board.)
- DC5.5-2.1CM power input cable
- RGB connecting cable
- normal 5050 white LED strip (10CM width) cable.